Alcatel-Lucent 6850-48 Reference Guide

VLAN Stacking Commands

page 23-6

OmniSwitch CLI Reference Guide

Configures the switch port as a VLAN Stacking Network Network Interface (NNI) port and associates the 
port with a customer SVLAN or management SVLAN. A network port connects to another provider 
bridge and carries both customer and provider traffic. 

ethernet-service svlan svid1[-svid2] nni {slot/port1[-port2] | linkagg agg_num} [stp | erp]

no ethernet-service svlan svid1[-svid2] nni {slot/port1[-port2] | linkagg agg_num} 

The VLAN ID number identifying the SVLAN (2–4094). 

The last VLAN ID number in a range of SVLANs that you want to 
specify (e.g. 10-12 specifies VLANs 10, 11, and 12).

The slot number for the module and the physical port number on that 
module (e.g., 3/1 specifies port 1 on slot 3).

The last port number in a range of ports that you want to configure on 
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).

The link aggregate ID number (0–31).

Specifies Spanning Tree control for the SVLAN-NNI association.

Specifies Ethernet Ring Protection (ERP) control for the SVLAN-NNI 
association.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove an association between an NNI port and an SVLAN. Note 

that when the last SVLAN association is removed, the NNI port reverts to a conventional switch port.

• This SVLAN ID specified with this command must already exist in the switch configuration. Only 

SVLAN IDs are accepted; IPMVLAN IDs are not supported with this command.

• When this command is used, the default VLAN for the NNI port is changed to a VLAN reserved by the 

switch.for applications such as VLAN Stacking. The reserved VLAN is not configurable using stan-
dard VLAN management commands.

• Associating a network port to an SVLAN is required.