Справочное Руководство для Alcatel-Lucent 6850-48
VLAN Stacking Commands
page 23-6
OmniSwitch CLI Reference Guide
September 2009
ethernet-service svlan nni
Configures the switch port as a VLAN Stacking Network Network Interface (NNI) port and associates the
port with a customer SVLAN or management SVLAN. A network port connects to another provider
bridge and carries both customer and provider traffic.
port with a customer SVLAN or management SVLAN. A network port connects to another provider
bridge and carries both customer and provider traffic.
ethernet-service svlan svid1[-svid2] nni {slot/port1[-port2] | linkagg agg_num} [stp | erp]
no ethernet-service svlan svid1[-svid2] nni {slot/port1[-port2] | linkagg agg_num}
Syntax Definitions
svid1
The VLAN ID number identifying the SVLAN (2–4094).
-svid2
The last VLAN ID number in a range of SVLANs that you want to
specify (e.g. 10-12 specifies VLANs 10, 11, and 12).
specify (e.g. 10-12 specifies VLANs 10, 11, and 12).
slot/port1
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
module (e.g., 3/1 specifies port 1 on slot 3).
-port2
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
agg_num
The link aggregate ID number (0–31).
stp
Specifies Spanning Tree control for the SVLAN-NNI association.
erp
Specifies Ethernet Ring Protection (ERP) control for the SVLAN-NNI
association.
association.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use the no form of this command to remove an association between an NNI port and an SVLAN. Note
that when the last SVLAN association is removed, the NNI port reverts to a conventional switch port.
• This SVLAN ID specified with this command must already exist in the switch configuration. Only
SVLAN IDs are accepted; IPMVLAN IDs are not supported with this command.
• When this command is used, the default VLAN for the NNI port is changed to a VLAN reserved by the
switch.for applications such as VLAN Stacking. The reserved VLAN is not configurable using stan-
dard VLAN management commands.
dard VLAN management commands.
• Associating a network port to an SVLAN is required.
parameter
default
stp | erp
stp