Alcatel-Lucent 6850-48 Reference Guide
MPLS LDP Commands
OmniSwitch CLI Reference Guide
September 2009
page 24-33
show router ldp bindings
Displays the contents of the MPLS Label Information Base (LIB).
This section describes the base command (show router ldp bindings). Optional keywords are listed
below and described as separate commands later in this chapter.
below and described as separate commands later in this chapter.
show router ldp bindings
[fec-type {services | prefixes | fec-num} [session ip-address[:label-space]]]
[ingress-label start-label [end-label]]
[egress-label start-label [end-label]]
[prefix ip-prefix/mask [session ip-address[:label-space]]]
[active [prefix ip-prefix/mask]]
[vc-type vc-type [vc-id vc-id [session ip-address [:label-space]]]]
[service-id service-id]
[ingress-label start-label [end-label]]
[egress-label start-label [end-label]]
[prefix ip-prefix/mask [session ip-address[:label-space]]]
[active [prefix ip-prefix/mask]]
[vc-type vc-type [vc-id vc-id [session ip-address [:label-space]]]]
[service-id service-id]
Syntax Definitions
N/A.
Defaults
By default, the entire contents of the LIB is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
Use the optional parameters provided with this command to display specific information for LDP label-
FEC (Forwarding Equivalence Class) bindings.
FEC (Forwarding Equivalence Class) bindings.
Examples
-> show router ldp bindings
LDP LSR ID: 10.10.10.5
Legend: U = Label In Use, N = Label Not In Use, W = Label Withdrawn,
S = Status Signaled Up, D = Status Signaled Down,
E = Epipe Service, V = VPLS Service, M = Mirror Service,
A = Apipe Service, F = Fpipe Service, I = IES Service, R = VPRN service,
P - Ipipe Service
TLV = (Type, Length: Value)
LDP Prefix Bindings
Prefix Peer IngLbl EgrLbl EgrIntf/LspId EgrNextHop
------------------+---------------+-------+------+-------------+---------------
10.10.10.5/32 10.11.0.6 131071U -- -- --
10.11.0.6/32 10.11.0.6 -- 131068 -- --
No. of Prefix Bindings: 2