Netopia 2e-h User Guide
Cayman 2E-H User’s Guide
Using the Command Line Interface
November 2000
4-19
CONFIG
Commands
Commands
This section describes the keywords and arguments for the various
CONFIG commands.
CONFIG commands.
BNCP Settings
set bncp option {on | off }
Enables or disables bridging over a PPP link. Typically used when the
PPP peer doesn't support IPCP encapsulation.
PPP peer doesn't support IPCP encapsulation.
Bridging Settings
Bridging lets the Cayman 2E-H use MAC (Ethernet hardware)
addresses to forward non-TCP/IP traffic from one network to
another. When bridging is enabled, the Cayman 2E-H maintains a
table of up to 255 MAC addresses. Entries that are not used within 10
minutes are dropped. If the bridging table fills up, the oldest table
entries are dropped to make room for new entries.
addresses to forward non-TCP/IP traffic from one network to
another. When bridging is enabled, the Cayman 2E-H maintains a
table of up to 255 MAC addresses. Entries that are not used within 10
minutes are dropped. If the bridging table fills up, the oldest table
entries are dropped to make room for new entries.
set bridge option { on | off }
Enables or disables bridging services in the Cayman 2E-H. You must
enable bridging services within the Cayman 2E-H before you can
enable bridging for a specific interface.
enable bridging services within the Cayman 2E-H before you can
enable bridging for a specific interface.
set bridge ethernet [ A | B ] option { on | off }
Enables or disables bridging services for the Ethernet interface.
set bridge ethernet [ A | B ] filters pppoe-only
{ on | off }
Enables or disables bridging services for the specified Ethernet
interface.
interface.
set bridge interwan-bridging { on | off }
Enables or disables bridging between remote networks.