Quantum atl 7100 Installation Instruction
Chapter 3 Installing the Library
Setting SCSI Addresses and Running the Library Self-Test
Setting SCSI Addresses and Running the Library Self-Test
28
Quantum|ATL 7100 Series Facilities Planning and Installation Guide
Setting SCSI Addresses and Running the Library Self-
Test
Test
3
After power is applied to the library, you need to do the following:
•
Set the library SCSI address
•
Set tape drive SCSI addresses
•
Run a library self-test
Refer to the Quantum|ATL 7100 Series Tape Library Operator’s Guide
for a description of how to set SCSI addresses and run a library
self-test.
for a description of how to set SCSI addresses and run a library
self-test.
Connecting the Library to the Host Controller
3
This section explains how to connect the host cables to the library.
The library is shipped with the internal cabling configured for four
separate host SCSI connections (four-wire) with all busses
terminating externally. Alternate host connection configurations
are discussed in
The library is shipped with the internal cabling configured for four
separate host SCSI connections (four-wire) with all busses
terminating externally. Alternate host connection configurations
are discussed in
of this
guide.
Note:
Internal SCSI cabling changes are required to configure
the library for a configuration different than the default.
Any additional cables required for internal cabling
changes are provided in the library accessories kit. The
accessories kit does NOT include any additional cabling
or terminators for connection to the host computer.
the library for a configuration different than the default.
Any additional cables required for internal cabling
changes are provided in the library accessories kit. The
accessories kit does NOT include any additional cabling
or terminators for connection to the host computer.