Sony str-dn1020 User Guide
118
GB
D:\NORM'S JOB\SONY HA\SO0126\STR-DN1020\4282218111_GB Web\GB07ADD_STR-
DN1020-CEL.fm
DN1020-CEL.fm
masterpage: Left
STR-DN1020
4-282-218-11(1)
No image appears on the TV.
• Select the appropriate input using the input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio equipment away from
• Move your audio equipment away from
the TV.
• Assign the equipment video input
correctly.
• The input signal should be same as the
input function when you are up-converting
an input signal with this receiver
an input signal with this receiver
• When you use an HDMI-DVI conversion
cable for the connection, the image may
not be output correctly.
not be output correctly.
• Make sure that cables are correctly and
securely connected to equipment.
• Depending on the playback equipment,
you may need to set up the equipment.
Refer to the operating instructions
supplied with each equipment.
Refer to the operating instructions
supplied with each equipment.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound,
especially for the 1080p, Deep Color
(Deep Colour) or 3D transmission.
especially for the 1080p, Deep Color
(Deep Colour) or 3D transmission.
No 3D image appears on the TV.
• Depending on the TV or the video
equipment, 3D images may not be
displayed. Check the 3D image formats
supported by the receiver (page 126).
displayed. Check the 3D image formats
supported by the receiver (page 126).
When the receiver is in standby mode,
there is no image output from the TV.
there is no image output from the TV.
• When the receiver enters into standby
mode, image is from the last HDMI
component selection before you turned off
the receiver. If you are enjoying other
equipment, play the equipment and
perform the One-Touch Play operation, or
turn on the receiver to select the HDMI
equipment you want to enjoy.
component selection before you turned off
the receiver. If you are enjoying other
equipment, play the equipment and
perform the One-Touch Play operation, or
turn on the receiver to select the HDMI
equipment you want to enjoy.
• Make sure “Pass Through” is set to “ON”
in the HDMI Settings menu if you connect
equipment not compatible with the
“BRAVIA” Sync to the receiver (page 98).
equipment not compatible with the
“BRAVIA” Sync to the receiver (page 98).
The image of the COMPONENT VIDEO
MONITOR OUT is corrupted.
MONITOR OUT is corrupted.
• The resolution of output signals from the
COMPONENT VIDEO MONITOR OUT
jacks may not be supported by your TV. In
this case, select the appropriate resolution
on the receiver (page 97).
jacks may not be supported by your TV. In
this case, select the appropriate resolution
on the receiver (page 97).
Recording cannot be carried out.
• Check that the equipment is connected
correctly.
• Select the source equipment using the
input buttons (page 46).
The GUI menu does not appear on the
TV screen.
TV screen.
• Press GUI MODE repeatedly to select
“GUI ON”. If the GUI menu still does not
appear on the TV screen, press MENU.
appear on the TV screen, press MENU.
• Check that the TV is connected correctly.
• The resolution of output signals from the
• The resolution of output signals from the
video jacks may not be supported by your
TV. In this case, select the appropriate
resolution on the receiver (page 97).
TV. In this case, select the appropriate
resolution on the receiver (page 97).
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antennas (aerial) as shown below.
antennas (aerial) as shown below.
Image
Tuner
Receiver
Outdoor FM antenna (aerial)