Sony DCR-PC1000 Manual

DCR-PC1000 2-591-678-11(1)

The rechargeable battery will be fully 
discharged in about 

 3 months if you do 

not use your camcorder at all without the 
AC adaptor connected or the battery pack 
attached. However, even if the pre-installed 
rechargeable battery is not charged, the 
camcorder operation will not be affected as 
long as you are not recording the date.



Connect your camcorder to a wall outlet 
using the supplied AC Adaptor or the 
Handycam Station, and leave it with the 
POWER switch set to (CHG) OFF for more 
than 24 hours.



  While pressing on the tab, inset your 

fingernail into the slit to pull out the 
battery case.



  Place a new battery with the + side facing 

up.



  Insert the battery case back into the 

Remote Commander until it clicks. 

Tab

Battery may explode if mistreated. Do not 
recharge, disassemble or dispose of in fire.

Danger of explosion if battery is 
incorrectly replaced. Replace only with 
the same or equivalent type recommended 
by the manufacturer.
Discard used batteries according to the 
manufacturer’s instructions.

•  When the lithium battery becomes weak, the 

operating distance of the Remote Commander 
may shorten, or the Remote Commander may 
not function properly. In this case, replace the 
battery with a Sony CR2025 lithium battery. 
Use of another battery may present a risk of fire 
or explosion.