Roland RS-50 Owner's Manual
48
Creating a patch (Patch mode)
Resonance
This boosts the region near the cutoff frequency to add a distinctive
character to the sound. Raising this value excessively may cause
oscillation and distortion. This is linked with the operation of the
[RESONANCE] knob of the panel (p. 29).
character to the sound. Raising this value excessively may cause
oscillation and distortion. This is linked with the operation of the
[RESONANCE] knob of the panel (p. 29).
VALUE:
-64–+63
•
Adjusting the attack or decay of the sound
(Envelope)
(Envelope)
Each original tone of the RS-50 includes envelope settings, but you
can use patch editing to apply relative adjustments to these settings.
Depending on the tone you select, editing may not produce
noticeable change in the sound. You cannot change the sustain level.
can use patch editing to apply relative adjustments to these settings.
Depending on the tone you select, editing may not produce
noticeable change in the sound. You cannot change the sustain level.
Attack Time
Adjusts the envelope attack time. This is linked with the operation of
the [ATTACK] knob of the panel (p. 28).
the [ATTACK] knob of the panel (p. 28).
VALUE:
-64–+63
Decay Time
Adjusts the envelope decay time. This is linked with the operation of
the [DECAY] knob of the panel (p. 28).
the [DECAY] knob of the panel (p. 28).
VALUE:
-64–+63
Release Time
Adjusts the envelope release time. This is linked with the operation
of the [RELEASE] knob of the panel (p. 28).
of the [RELEASE] knob of the panel (p. 28).
VALUE:
-64–+63
Saving a patch
When you have edited a patch to your liking, use the following
procedure to save it.
procedure to save it.
1.
Press [PATCH] so it is lit and you are in Patch mode.
2.
Select the patch that you want to edit.
3.
Edit the patch.
4.
When the sound is to your liking, press [WRITE].
Use VALUE [-]/[+] to specify the number in which the user
patch is to be saved (U001–U128).
patch is to be saved (U001–U128).
fig.r03-01_40
As shown above, the display will show only the user patch
number if nothing has yet been saved to that number.
number if nothing has yet been saved to that number.
If you save to a number in which a user patch has already been
saved, be aware that the previously saved settings will be
overwritten and lost.
saved, be aware that the previously saved settings will be
overwritten and lost.
5.
Press [ENTER].
6.
Use VALUE [-]/[+] to specify the category for the user patch
you want to save.
fig.r03-02_40
7.
Press [ENTER] once again to execute.
When the user patch has been saved, the display will indicate
“COMPLETED.” This completes the procedure.
“COMPLETED.” This completes the procedure.
If you decide not to save the user patch, press [EXIT].
If you do not change
have the same name as the one you selected in step 2.
RS-50_e3.book 48 ページ ２００３年１１月７日 金曜日 午後７時１分