Edirol LVS-400 Supplementary Manual
14
About the New Functions
Here’s how you can temporarily black out the output image.
1
Press [OUTPUT ON/OFF].
When you press the LVS-400's [OUTPUT ON/OFF], the button flashes, and the output
from the OUTPUT connector turns black. The image is output when the button is
pressed again.
from the OUTPUT connector turns black. The image is output when the button is
pressed again.
Blacking out the output image
Adjusting the Time for the Image to Fade to Black
You can have the image output from the OUTPUT connector gradually fade out
to black over a preset length of time.
to black over a preset length of time.
1. Connect a monitor display to the MONITOR OUT connector.
2. Hold down [OUTPUT ON/OFF] for at least three seconds.
“Time = *” (“*” indicates a number of 0–9) appears in the monitor display
connected to the MONITOR OUT connector.
connected to the MONITOR OUT connector.
3. While continuing to hold down [OUTPUT ON/OFF], turn the TRANSITION
TIME knob.
The transition time lengthens as the value is increased.
4. When you are finished adjusting the position, release [EFFECTS].
Time changes remain in effect
until the power is turned off.
Turning off the power restores
the time to the original factory
default settings (TIME=3).
until the power is turned off.
Turning off the power restores
the time to the original factory
default settings (TIME=3).
The OUTPUT ON/OFF button
flash during transitions and
switching.
flash during transitions and
switching.
A
A
TRANSITION
TIME
A
LVS-400v2_e1.book 14 ページ 2004年8月10日 火曜日 午後5時7分