Enterasys 9f106-01 User Manual

 

2-3

The Reset Switch

 

The Reset switch is located on the front panel, under the top plastic tab, as shown 
in Figure 2-2. It serves two functions:

•

Pressing the Reset switch twice within three seconds causes the processor to 
reset.

•

Pressing and holding the switch on for three or more seconds causes the 
module to shutdown. Pressing and holding again for three seconds restarts the 
module.

SNMP management may be used to disable this switch to enhance module 
security. 

 

Figure 2-2. The Reset Switch

 

Local Management is accessed by attaching a management console at the RJ-45 
CON port of the 9F106-01. The console connection supports a Digital Equipment 
Corporation VT 320™ terminal or PC emulation of one of these terminals.

Table 2-1 lists the setup requirements for the local management console. If your 
terminal is a Digital Equipment Corporation VT 320™ terminal, press 

 

to access 

the Setup Directory. If you have a terminal emulation of the Digital Equipment 
terminals, refer to your equipment user manual for setup procedures.

SMB

CPU

Reset Switch