Enterasys 1805 User Guide

36 ELS100-S24TX2M User Interface

ELS100-S24TX2M

Viewing the Current Port Configuration

The Port Information screen displays the port type, status, link state, and

flow control in use, as well as the communication speed and duplex mode.

To change any of the port settings, use the Port Configuration menu. The

parameters shown in the following figure and table are for the RJ-45 ports.

Figure 2-19. Port Information

SmartSTACK Local Management -- ELS100-S24TX2M

Port Information :

Unit 1 Port 1-12

Port Type Operational Link

FlowControl

Speed and

InUse Duplex InUse
-------------------------------------------------------------------------------------------------------

1. 10/100TX

YES

DOWN -----------------

----------------

2. 10/100TX

YES

DOWN -----------------

----------------

3. 10/100TX

YES UP

802.3x

100-FULL

4. 10/100TX

YES

DOWN -----------------

----------------

5. 10/100TX

YES

DOWN -----------------

----------------

6. 10/100TX

YES

NONE

100-HALF

7. 10/100TX

YES

802.3x

100-FULL

8. 10/100TX YES UP

BACK_PRESSURE 10-FULL

9. 10/100TX

YES UP

BACK_PRESSURE 10-FULL

10. 10/100TX

YES

BACK_PRESSURE 10-FULL

11. 10/100TX

YES

BACK_PRESSURE 10-FULL

12. 10/100TX

YES

BACK_PRESSURE 10-FULL

Use <TAB> or arrows keys to move. <Enter> to select.

Parameter

Description

Type

Shows port type as:
10/100TX : 10Base-T / 100Base-TX
100FX :

100Base-FX

1000SX :

1000Base-SX

1000LX

: 1000Base-LX

Operational

Shows if the port is functioning or not.

Link

Indicates if the port has a valid connection to an external device.

FlowControl InUse

Shows the flow control type in use. Flow control can eliminate
frame loss by “blocking” traffic from end stations connected
directly to the switch. Back pressure is used for half duplex and
IEEE 802.3x for full duplex. Note that flow control should not be
used if a port is connected to a hub.

Speed and
DuplexInUse

Displays the current port speed and duplex mode used.