Rocketfish RF-RBWS02 User Guide
12
Setting up your wireless speaker kit
Powering your wireless speaker
To connect your wireless speaker to an AC power outlet:
1
Connect one end of the power cord to the DC IN connector on the back
of the speaker.
2
Plug the other end of the power cord into an AC power outlet. The power
indicator on the speaker turns on and goes into standby mode.
Battery operation
Your Wireless speaker is compatible with either Alkaline or NiMH
rechargeable batteries. It uses auto-sensing technology which allows
the unit to detect which type of batteries are used, so there is nothing
you have to do. Make sure that you only use either Alkaline or NiMH
rechargeable batteries.
rechargeable batteries. It uses auto-sensing technology which allows
the unit to detect which type of batteries are used, so there is nothing
you have to do. Make sure that you only use either Alkaline or NiMH
rechargeable batteries.
To load batteries into the wireless speaker:
1
Remove the three screws holding the bottom cover on the wireless
speaker, then remove the cover.
2
Insert eight NiMH rechargeable or alkaline batteries into the battery
compartment, making sure that the polarity (+ and -) on the batteries
matches the markings inside the battery compartment.
6
Volume
buttons (stream)
Press to adjust the volume of all devices receiving the same audio stream.
7
(mute - all)
Press to mute all devices. Press again to unmute the stream that receives
the IR command. To unmute other streams, you must point the remote
control at a device muted for that stream.
the IR command. To unmute other streams, you must point the remote
control at a device muted for that stream.
8
Next Source button
Press to select the next source.
#
Feature
Description
/
RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 12 Thursday, August 27, 2009 7:39 PM