Sony HT-DDW665 User Guide
masterpage:Left
lename[E:\SEM_Janet\J9040000_4252086821DDW665US\4252086821\GB03CON_HT-
DDW665-US.fm]
12
US
model name1[HT-DDW665]
[4-252-086-82(1)]
x
PL. XXXX
(Surround speaker placement)
Lets you specify the height of your surround speakers
for proper implementation of the surround effects of
the Cinema Studio EX modes (page 18).
for proper implementation of the surround effects of
the Cinema Studio EX modes (page 18).
• LOW
Select if the height of your surround speakers
corresponds to section A.
corresponds to section A.
• HIGH
Select if the height of your surround speakers
corresponds to section B.
corresponds to section B.
Adjust the speaker levels and balance while
listening to the test tone from your listening
position. Use the remote for the operation.
listening to the test tone from your listening
position. Use the remote for the operation.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
centered at 800 Hz.
1
Press ?/1 to turn on the receiver.
2
Press TEST TONE.
“T. TONE” appears in the display and the
test tone is output from each speaker in
sequence.
Front (left)
test tone is output from each speaker in
sequence.
Front (left)
t Center t Front (right) t
Surround (right)
t Surround (left) t
Sub woofer
3
Adjust the speaker levels and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu settings,
see page 20.
see page 20.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/– on the remote or
turn MASTER VOLUME –/+ on the receiver.
turn MASTER VOLUME –/+ on the receiver.
• The adjusted value are shown in the display
during adjustment.
4
Press TEST TONE again after
adjustment.
adjustment.
The test tone turns off.
Notes
• Although these adjustments can also be made via the
front panel using the LEVEL menu (when the test
tone is output, the receiver switches to the LEVEL
menu automatically), we recommend you follow the
procedure described above and adjust the speaker
levels from your listening position using the remote.
tone is output, the receiver switches to the LEVEL
menu automatically), we recommend you follow the
procedure described above and adjust the speaker
levels from your listening position using the remote.
• The bass redirection circuitry is always active, so you
may hear some sound output from the sub woofer
when test tone is output from other speakers.
However, this is not a malfunction.
when test tone is output from other speakers.
However, this is not a malfunction.
SL
SR
60
30
A
B
A
B
6: Adjusting the speaker
levels and balance
levels and balance
— TEST TONE
GB01COV_HT-DDW665-US.book Page 12 Monday, April 26, 2004 10:03 AM