Yamaha RX-V1065 User Guide

This unit has a Yamaha Parametric Acoustic Optimizer (YPAO). With the YPAO, this unit automatically adjusts the 
output characteristics of your speakers based on speaker position, speaker performance, and the acoustic characteristics 
of the room. We recommend that you first adjust the output characteristics with the YPAO when you use this unit. 

Check the following points.
Before starting the automatic setup, check the 
following.
• All speakers and subwoofer are connected 

properly.

• Headphones are disconnected from this unit.
• The video monitor is connected properly.
• This unit and the video monitor are turned on.
• This unit is selected as the video input source of the 

video monitor.

• The connected subwoofer is turned on and the 

volume level is set to about half way (or slightly 
less).

• The crossover frequency controls of the connected 

subwoofer are set to the maximum.

Connect the supplied optimizer microphone 
to the SOPTIMIZER MIC jack on the front 
panel.

“MIC ON. View GUI MENU” appears on the front panel 
display. 
The GUI screen appears on the video monitor.

y

• You can bring up the above menu screen from the Setup menu (page 55).

y

• It is recommended that you use a tripod or something similar to fix the 

optimizer microphone at the same height as your ears would be when 
seated in your listening position. You can fix the optimizer microphone to 
the tripod with the attaching screw of the tripod.

Caution
• Be advised that it is normal for loud test tones to be 

output during the “Auto Setup” procedure. Do not 
allow small children to enter the room during the 
procedure.

• To achieve the best results, make sure the room is as 

quiet as possible while the “Auto Setup” procedure is 
in progress. If there is too much ambient noise, the 
results may not be satisfactory.

y

• You can manually adjust the output characteristics of your speakers 

with “Manual Setup” in the Setup menu (page 55).

VOLUME

MIN

MAX

CROSSOVER/

HIGH CUT

MIN

MAX