Yamaha RX-V1065 User Guide

When the speakers are connected to EXTRA 
SP terminals, press jCursor k repeatedly 
to select “Extra Speaker Assignment” and 
then press jCursor l / h to select how to 
use EXTRA SP terminals from “Zone2”, 
“Presence” or “None”.
If this unit does not work when you press jCursor, 
press iON SCREEN once and then operate this 
unit.

To select sound characteristics for 
adjustment, press jCursor n to select “EQ 
Type” and then press jCursor l / h.
If this unit does not work when you press jCursor, 
press iON SCREEN once and then operate this 
unit. 
This unit has a parametric equalizer that adjusts the 
output levels for each frequency range. The equalizer 
is adjusted to produce a cohesive sound field based on 
automatically measured speaker characteristics. 
In “EQ Type”, you can select the following 
parametric equalizer characteristics suitable for the 
desired sound characteristics.

Natural
This adjusts all speakers to achieve natural sound. 
Select this if sounds in the high frequency range seem 
too strong when “EQ Type” is set to “Flat”.

Flat
This adjusts each speaker to obtain the same 
characteristics. Select this if your speakers have 
similar qualities.

Front
This adjusts each speaker to obtain the same 
characteristics as the front left and right speakers. 
Select this if your front left and right speakers have 
significantly better qualities than the other speakers.

Press jCursor n to select “Start” and then 
press jENTER to start the setup procedure.
A countdown starts and a measurement starts in 10 
seconds. A loud test tone is output during 
measurement.

• During the automatic setup procedure, do not perform any 

operation on this unit.

• Press jCursor k to cancel the automatic setup procedure.

When measurement is successfully completed, 
“YPAO Complete” appears on the front panel display 
and the measurement result appears on the GUI 
screen.

Speaker Config
Displays the number of speakers connected to this unit in 
the following order: 
Total of Front and Center/Total of Surround and Surround 
Back/Subwoofer

Distance (Min / Max)
Displays the speaker distance from the listening position 
in the following order: 
Closest speaker distance/Farthest speaker distance

Level (Min / Max)
Displays the speaker output levels in the following order: 
Lowest speaker output level/Highest speaker output level

• If “Error” appears on the GUI screen during “Auto Setup”, measurement 

is canceled and the type of error is displayed. For details, see “When an 
error message is displayed during measurement” (page 21).

• If problems occur during measurement, “Check xx warning(s)” (xx 

indicates the number of warnings) appears in red. For details, see “When 
a warning message is displayed after measurement” (page 21).

Press jENTER to confirm the settings.
The speaker characteristics are adjusted according to 
measurement results. 
To cancel the operation, press jCursor l / h to 
select “Cancel” and press jENTER. 
When the following screen appears, remove the 
optimizer microphone. “Auto Setup” is now 
complete.

y

• If you do not want to apply the measurement results, select “Cancel”.
• Perform “Auto Setup” again if you change the number or positions of 

speakers.

• If you press jENTER before removing the optimizer microphone, 

“Auto Setup” of “Speaker Setup” in the Setup menu (page 55) is 
displayed.

Measurement takes about 3 minutes. To obtain precise 
results, stay where you will not disturb the 
measurement, such as to the side of or behind the 
speakers or outside the room.

The optimizer microphone is sensitive to heat. Store it 
in a cool place and away from direct sunlight after 
measurement. Do not leave it in a place where it will be 
subjected to high temperatures such on an AV 
component.