Yamaha RX-V2700 Owner's Manual

■

SPEAKER IMP.

Use this feature to set the speaker impedance of this unit 
so that it matches that of your speakers.
Choices: 

Ω

, 6

ΩMIN

• Select  “

8ΩMIN” to set the speaker impedance to 8 Ω .

• Select “6

ΩMIN” to set the speaker impedance to 6 Ω .

■

USER PRESET

Use this feature to reset all the parameters of this unit to 
the initial factory settings (see page 149).
Choices: 

, RESET

• Select “CANCEL” not to reset any parameters of this 

unit.

• Select “RESET” to reset the parameters of this unit.

• This setting completely resets all the parameters of this unit. 

However, the advanced setup menu parameters will not be 
initialized.

• The initial factory settings are activated next time you turn on 

this unit.

■

REMOTE SENSOR

Use this feature to activate or deactivate the signal-
receiving capability of the remote control sensor on the 
front panel of this unit.
Choices: 

, OFF

• Select “ON” if you want to activate the signal-

receiving capability of the remote control sensor.

• Select “OFF” if you want to deactivate the signal-

receiving capability of the remote control sensor.

We recommend setting the parameter to “ON” in most cases.

■

WAKE ON RS232C

Use this feature to set this unit to transmit data via the RS-
232C interface when this unit is in the standby mode.
Choices: YES, NO
Initial setting:
[U.S.A. and Canada models]: YES
[Other models]: NO
• Select “YES” to set this unit to transmit data via the 

RS-232C interface.

• Select “NO” to set this unit not to transmit data via the 

RS-232C interface.

■

RC AMP ID

Use this feature to set the AMP ID of this unit for remote 
control recognition (see page 121).
Choices: 

, ID2

• Select “ID1” when the remote control AMP ID library 

code is set to “2001”.

• Select “ID2” when the remote control AMP ID library 

code is set to “2002”.

You need to set the corresponding remote control AMP library 
code for the remote control (see page 121).

■

RC TUNER ID

Use this feature to set the TUNER ID of this unit for 
remote control recognition (see page 138).
Choices: 

, ID2

• Select “ID1” when the remote control TUNER ID 

library code is set to “2602”.

• Select “ID2” when the remote control TUNER ID 

library code is set to “2603”.

You need to set the corresponding remote control TUNER library 
code for the remote control (see page 138).

■

RC XM ID

Use this feature to set the XM ID of this unit for remote 
control recognition (see page 138).
Choices: 

, ID2

• Select “ID1” when the remote control XM ID library 

code is set to “2604”.

• Select “ID2” when the remote control XM ID library 

code is set to “2605”.

You need to set the corresponding remote control XM library 
code for the remote control (see page 138).

8ΩMIN

Front

The impedance of each 
speaker must be 8

Ω or 

higher.

Center

The impedance of each 
speaker must be 8

Ω or 

higher.

Surround

Surround back

6ΩMIN

Front

The impedance of each 
speaker must be 4

Ω or 

higher.

Center

The impedance of each 
speaker must be 6

Ω or 

higher.

Surround

Surround back