Yamaha RX-V3900 User Guide

■ Using TRIGGER OUT jacks for Zone 2 and Zone 3

This unit is equipped with two TRIGGER OUT jacks. You can turn on and off the component corresponding to the 
selection of the input source of the desired zone or turning on and off the desired zone by configuring the “Trigger 
Output” settings (page 100).

You can select the zone you want to control by using the 
control buttons on the front panel or on the remote control. 

■ Basic operation

Press O

ZONE 2 or OZONE 3 on the front 

Press O

ZONE CONTROLS on the front 

Each time you press OZONE CONTROLS, the 
front panel display changes as shown below, and the 
indicator for the currently selected zone flashes for 
approximately 10 seconds. However, no indicator 
flashes when the main zone is selected.

ZONE2
Controls the Zone 2 amplifier or tuner functions.

ZONE3
Controls the Zone 3 amplifier or tuner functions.

y

You must complete this step within 10 seconds while the 
selected zone flashes in the front panel display. Otherwise, 
the currently selected zone mode is automatically 
canceled.

y

To turn off the desired zone, press 

OZONE 2 or 

OZONE 3 again.

Press H

ZONE repeatedly to select the zone 

you want to control.
“MAIN”, “ZONE 2”, or “ZONE 3” indicator appears 
in the display window (4) on the remote control.

Press E

POWER to turn on the selected 

y

To turn off the desired zone, press DSTANDBY.

After the connections, turn on this unit and set the 
speaker terminal assignments with “Zone SP Assign” 
(page 96).