Yamaha yst-sw200 Owner's Manual

10

Set the VOLUME control to minimum.

Turn on the power supply to all the components.

Play the source and adjust the amplifier’s volume control
to the desired listening level.

Turn up the VOLUME control gradually to adjust the
volume balance between this unit and the main speakers.

Adjust the HIGH CUT control to the position where the
desired response can be obtained.

Set the PHASE switch to the position (NOM or REV)
where the desired bass effect can be obtained.

•

Once the volume balance between this unit and the main
speakers is adjusted, you can adjust the volume of your
whole sound system by using only the amplifier’s volume
control.
*

However, if this unit is connected to line output terminals
(except PRE OUT or SUBWOOFER OUT terminals) of
the amplifier, you must adjust the volume controls of this
unit and the amplifier individually.

•

For adjusting the VOLUME control, the HIGH CUT control
and the PHASE switch, refer to “FREQUENCY
CHARACTERISTICS” on the next page.

First set this control at about the main speakers’ rated
minimum reproduceable frequency.  Then turn up the
VOLUME control gradually and set it at a level where you can
obtain a little more bass effect than when this unit is not used.
On the basis of this setting, if desired, adjust the VOLUME
control and the HIGH CUT control again.
*

The main speakers’ minimum reproduceable frequency can
be looked up in the speakers’ catalog or owner’s manual.

For these operations, use the remote control transmitter at the listening position.