Yamaha yst-sw200 Owner's Manual

➊

POWER indicator

Illuminates when the POWER switch is turned ON, and
goes off when turned OFF.

* STANDBY mode (Australia, U.K. and Europe models)

While the power is on, pressing the POWER key on the
remote control transmitter switches the unit to the
STANDBY mode. (In this mode, the indicator is half
illuminated.)

➋

OUTPUT indicator

Illuminates when the OUTPUT switch is turned ON, and
goes off when turned OFF.

➌

Remote control sensor

Receives the signals from the remote control transmitter.

➍

POWER switch

Turns the power of this unit ON and OFF whenever
pressed. When this switch is turned ON, the indicator over
the POWER switch on the front panel illuminates.

➎

HIGH CUT control

Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and not output).
For easier operation, use the HIGH-CUT
UP/DOWN keys on the remote control
transmitter.

* One graduation of this control indicates

10 Hz.

➏

VOLUME control

Adjusts the volume level.  
For easier operation, use the VOLUME UP/DOWN keys
on the remote control transmitter.

➐

PHASE switch

Normally this switch is to be set to the normal (NOM)
position.  However, according to your speaker systems or
the listening condition, there may be a case when better
sound quality is obtained by setting this switch to the
reverse (REV) position.  Select the better position by
monitoring the sound.  

➑

OUTPUT switch

Turns the output of this unit ON and OFF whenever
pressed.  When this switch is turned ON, the OUTPUT
indicator on the front panel illuminates.

9

POWER on mode

STANDBY mode