Korg m50-73 User Guide

 When executing a Create Directory or File 

 operation, a directory or file of the same name 

already exists on the media.

 When executing the Media mode Utility 

 command without using wild cards, the copy 

destination contained a file of the same name as the 
copy source.

• Either delete the existing directory or file, or specify 

a different name.

 You attempted to load or open a file whose 

format was incorrect.

 When executing the Delete command in the 

Media mode Utility page, the specified file did not 
exist.

 When executing the Copy command in the 

Media mode Utility page, and you used a wild card to 
specify the copy file name, the specified file was not 
found. Alternatively, the length of the copy source path 
name exceeded 76 characters.

 In Media mode when you used the Open 

button to open a directory, the path length including 
the selected directory name exceeded 76 characters.

• Check the file or directory.

 The filename that you specified when saving 

a file or creating a directory contained invalid 
characters. To solve this problem:

• Change the filename you are specifying. Filenames 

not permitted by MS-DOS cannot be used as a 
filename.

 You attempted to load a file that was not a 

Standard MIDI File.

 You attempted to load a Standard MIDI File 

that was timecode-based.

 You attempted to load a Standard MIDI File 

of a format other than 0 or 1.

When realtime-recording a single track, you 

attempted to begin recording with the master track as 
the current track.

• Select a MIDI track for recording, instead of the 

Master Track.

The attempted edit operation would cause 

the track length to exceed 999 measures.

• Delete unnecessary measures.

 When loading a Standard MIDI File, the 

number of events in a measure exceeded the maximum 
(approximately 65,535 events).

 The attempted edit operation would cause 

the maximum number of events in a measure 
(approximately 65,535) to be exceeded. 

To solve either of these problems:

• Use event editing etc. to delete unwanted data.

 When executing the Copy command in the 

Media mode Utility page, the media was exchanged or 
ejected, and it was not possible to copy between 
separate media on the same drive.

 You selected a medium that does not allow 

writing.

The other writing-destination media is 

write-protected.

• Turn off write protect on the other media, and 

execute the command once again.

 When editing a song, track or pattern in 

Sequencer mode, the total data of all songs has used up 
all of the sequence data memory, and further editing is 
not possible. To solve this problem:

• Delete other song data etc. to regain free memory.

 While realtime recording in Sequencer 

mode, there is no more free memory to accommodate 
the recorded data, so recording has been forcibly 
halted. To solve this problem:

• Delete other song data etc. to regain the amount of 

free memory.

 While receiving exclusive data in Media 

mode Save Exclusive, all remaining internal memory 
was used up. To solve this problem:

• If you are receiving two or more sets of exclusive 

data, transmit them separately to the M50.

The internal program, combination, song, 

drum kit, user arpeggio pattern is protected.

The song was protected when you executed 

Auto Song Setup.

• In Global mode, turn off write-protect, and execute 

the write or load operation once again.

 While receiving MIDI System Exclusive 

data, the format of the received data was invalid, for 
example, because the size of the data was incorrect.