Zhone 2000 User Manual

- 11 -

switch, located on the back panel. This starts the IAD and it executes 
the boot process to begin normal operation.

2. Verify that the Power indicator on the front panel illuminates. 

With a serial cable connected, follow these steps to log in to the IAD:

1. Open a terminal emulation program (Hyperterminal, for example).
2. Select the COM port to which the IAD is connected.
3. Type or select the following settings and save your changes.

4. Press Enter. The IAD displays the log in message:

Enter Login ID > 

5. Type the default supervisor level user ID (Supervisor) (or your user 

ID if changed) and press Enter. Note that both the user ID and 
password are case-sensitive.

 below lists the default user IDs and passwords. 

For information on security levels, and user ID and password management 
see 

6. The IAD displays the password message:

Enter Password > 

7. Type the default password (supervisor, or your password if 

different) and press Enter.

8. If log in is not successful, the IAD displays the following message:

Invalid UserID or Password - Try again
Press any key to continue...

 

As the IAD boots, it sends status messages to the console 
port. If you are connected, you will see the boot sequence 
progress.

Bits per second

19,200

Stop bits

1

Data bits

8

Flow control

None

Parity

None

Emulation

ANSI or VT100

 

If the IAD does not respond, make sure the IAD is powered 
up, check the cable and connections, and review the settings.

User

<enter>

<Enter>

Network 
Administrator

NetMan

<Enter>

Supervisor

Supervisor

supervisor