Jet 756151 wh-45t - 45" english wheel User Guide
16
2. Loosen the spindle nut (D) then, using the
spindle wrench (Inset A) continue to turn until
the spindle breaks free of the arbor.
the spindle breaks free of the arbor.
Shaper Cutter Installation
Note: Spindle installation is described in the
previous section.
previous section.
When changing tools, making
adjustments, or doing clean-up and maint-
enance, always turn the machine off and
unplug the machine from its power source.
enance, always turn the machine off and
unplug the machine from its power source.
Locking the Spindle
1. Locate
the
spindle lock (L, Fig. 14) accessible
through the door on the right side of the
cabinet. Pull out and rotate 90º right or left,
resetting the knob into the indent.
cabinet. Pull out and rotate 90º right or left,
resetting the knob into the indent.
Attempt to turn the spindle assembly
(B, Fig. 14) by hand to verify that it is locked
and will not rotate.
(B, Fig. 14) by hand to verify that it is locked
and will not rotate.
Installing the Shaper Cutter
Referring to Figure 15:
2. Using an 8mm hex wrench (provided),
remove the socket head cap screw (F).
3. Remove
the
washer (E), keyed collar (C) and
all or as many collars (B) as necessary.
4. Place the shaper cutter (A) (not included)
onto the spindle, oriented in the proper
direction.
direction.
5. Place the collars (B) and keyed collar (C)
onto the spindle.
Note: Collars come in several widths and the
stacked selection (B) must be such that the
top of the keyed collar (C) sits slightly above
the top of the spindle (D). This will ensure
sufficient pressure to properly secure the
shaper cutter (A) when installation is
complete.
stacked selection (B) must be such that the
top of the keyed collar (C) sits slightly above
the top of the spindle (D). This will ensure
sufficient pressure to properly secure the
shaper cutter (A) when installation is
complete.
6. Replace
the
washer (E) and socket head cap
screw (F). Tighten screw with the 8mm hex
wrench provided.
wrench provided.
Unlocking the Spindle
7. Pull out the spindle lock (L, Fig. 14)
accessible through the door on the right side
of the cabinet. Rotate 90º right or left,
resetting the knob into the indent.
of the cabinet. Rotate 90º right or left,
resetting the knob into the indent.
Using gloves to prevent injury from the
shaper cutter, turn the spindle assembly by
hand to verify that it turns freely.
shaper cutter, turn the spindle assembly by
hand to verify that it turns freely.
Figure 15