Jet jj-6csdx User Manual

 

15 

 

Referring to Figure 17: 

The infeed table depth stop (A) limits the depth of 
a cut (set by adjusting the infeed table handwheel) 
to a maximum depth of 1/8”. For normal 
operations, the depth of cut should never exceed 
1/8", except for rabbetting operations. 

If a rabbeting operation is desired: 

1.  Lower the infeed table to 1/8", which will cause 

the depth stop limiter to engage. 

2.  Loosen the lock handle (B) and pull out on the 

stop handle (C). 

3.  Continue lowering the table to the desired 

depth of cut. 

Important: Never override the depth stop limiter 
unless performing rabbeting operations. 

 

After a period of use, the gibs may become loose 
and need adjusting.  

To adjust (refer to Figure 18): 

1.  Loosen setscrew locknuts (A) and gib lock 

screws (B). 

Note: The infeed table has three gib 
adjustment screws A (Infeed). The outfeed 
table has two gib adjustment screws 
A (Outfeed) and two gib lock wing screws (B). 

2.  Tighten each setscrew 1/4 turn starting at the 

bottom and working up.  If a 1/4 turn does not 
remove all play, take another 1/4 turn.  Repeat 
a 1/4 turn at a time for all three (or two) set 
screws until play is removed. 

3.  Tighten wing screws (B) and lock nuts (A). 

Important: If gibs are adjusted, also perform the 
Outfeed Table Adjustment to ensure the proper 
knife height in relation to the outfeed table.