Jet jj-6csdx User Manual

 

17 

  Planer knives are dangerously 

sharp. Use extreme caution when inspecting, 
removing, sharpening, or replacing knives into 
the cutterhead. Failure to comply may cause 
serious injury. 

1.  Disconnect machine from the power source. 

2.  Remove blade guard by turning the knob 

(A, Fig. 23) clockwise while lifting up on blade 
guard.   

3. Loosen 

four 

screws  (A, Fig. 24). 

\Note: Loosen screws by turning in a 
clockwise direction as viewed from the infeed 
table.  

Carefully remove the knife (C, Fig. 24), the 
lock bar with screws (B, Fig. 24). 

Repeat for the other two blades. 

4.  Before assembly, clean all parts thoroughly 

and clear cutterhead knife slots of any dust or 
debris. 

5.  Insert knife into the cutterhead channel making 

sure it faces the proper direction. 

6.  Insert lock bar and screws and tighten to hold 

in place.  Blades are set at the proper height 
when the top of the blade is 1/16" above the 
cutterhead.  Do not tighten firmly at this time. 

7.  Repeat for other two blades. 

8.  To set the knives to the outfeed table and to 

the same height in the cutterhead, see the 
Setting Outfeed Table to Cutterhead Knives 
section.