Garmin 10 Owner's Manual

I

NSTALLING

 

AND

 T

ESTING

1.  Connect the antenna plug to the appropriate female 

(receptacle) adapter cable. Connect the Fakra plug 

to the 

In connector on the GTM 10. The Fakra plug 

locks firmly in place.

Fakra 

connector

Female 

adapter

Antenna 

connector

If the antenna cable has a Fakra connector, no adapter 

cable is needed between the antenna cable and the 

GTM 10 In connector. Connect the Fakra antenna 

cable directly into the In connector of the GTM 10. 

Then use the supplied dual-ended Fakra cable to 

connect the GTM 10 to the radio, as described below.

2.  Connect the Fakra connector of the adapter cable to 

the 

Out connector of the GTM 10. Connect the male 

(plug) adapter cable into the radio receptacle.

Fakra 

connector

Male 

adapter

Radio 

receptacle

Route the mini-USB cable from behind the radio on the 

passenger’s side of the vehicle. If possible, thread the 

cable through an existing opening in the glove box or 

trim panel. Thread enough cable through the opening to 

reach the GPS device. Do not cut the mini-USB cable. 
If the mini-USB cable is not long enough to reach the 

GPS device, a 2-meter extension cable is available for 

purchase from the Garmin Web site at 

http://www 

 or from a Garmin dealer. 

Observe the LED: With the GTM 10 connected to the 

GPS device, turn on the GPS device. Service reception 

is indicated by the Green solid light, which may take 

up to five minutes to appear for initial data acquisition.