Garmin 10 Owner's Manual
GTM 10 Owner’s Manual
5
I
NSTALLING
AND
T
ESTING
Yellow dot-dash flashes: waiting for
initial country code, which is automatically supplied by
the Garmin GPS device.
Yellow fast flashes: searching table
for active entry.
Red/Green flashes: scanning for new
TMC FM stations.
Red solid light: momentary sync loss.
Green solid light: normal traffic data.
Green solid light: normal traffic data.
Verify Signal Strength: If you are inside a garage
where radio signals cannot be received, you may need
to take the vehicle outside.
Verify that you are in a service area: Check for
Verify that you are in a service area: Check for
service from the pay service or free services, if
available.
Check the Map: Check the map on the GPS device for
Check the Map: Check the map on the GPS device for
traffic alerts. Refer to the Owner’s Manual.
If these tests fail, either you are not in a service area,
If these tests fail, either you are not in a service area,
the purchased subscription needs to be activated, or the
installation might be faulty.
Step 6: Mount the GTM 10
If possible, place the GTM 10 where the LED can be
seen without dismantling the dashboard.
1. Mount the GTM 10 in one of the following ways:
• Attach with foam tape: clean and dry a flat
surface behind the dashboard. Remove the
backing from the foam tape and attach the GTM
10 to the flat surface.
• Hang freely: bind up any slack cable from the
mini-USB cable with a wire tie and let the GTM
10 hang freely behind the radio.
2. Check that all cables and the GTM 10 are secure
and not obstructed.
3. Replace all parts of the dashboard to their original
locations.
4. Repeat the testing as described in Step 5.