Planar C3 User Guide

 

Ask someone to help you lift and mount the display.  You also need a protective cloth on which to put the display 
screen-down (on a flat surface) to adjust and remove the mounting screws. 

Loosen the four top mounting 

screws until they protrude halfway 
from the display.  The screws must still 
be firmly seated.  Completely remove 
the four bottom screws.

 With a person on each side, lift the 

display and set the protruding screws 
into the top screw slots to hook the 
display onto the mounting bracket.  

Insert the four bottom screws into 

the mounting bracket and the display. 
Tighten all the screws. Use the lever on 
the bracket to adjust the tilt position 
of the display.

Refer to the display documentation for proper connection of the video cables, that is, from the display to the display 
controller.  After you make the connections, you can check that the cables are neatly routed and firmly attached to the cart.

Plug the power and video cables 

into each display.  The video cable for 
the first display is marked with tape.

Plug the power cord into 

the computer.

Plug the video cables into the 

computer.  (The cable for the first 
display plugs into the top port.)

Plug the keyboard and mouse 

cables into the computer.

Plug all power cords into the 

power strip.  Use the cable ties to 
bundle and secure the cords and 
cables.  (If using a UPS, plug the power 
cords into the power strip, plug the 
strip cord into the UPS, and plug the 
UPS cord into a grounded outlet.)

Plug the power strip cord into 

a grounded outlet.  Be sure that you 
make the connection to the power 
source last.  Refer to the display 
documentation before powering on 
the system.

To finish the integration, install the display driver and the Dome CXtra software onto the computer hard drive.  Install the 
display driver before you install the software.  Refer to the display or software documentation for more information.