Aethra d2000 lite User Manual

ISDN TESTER AND ANALYZER D2000

PRO

/D2000Lite/D2000                                                                                USER’S MANUAL

 

 

IP Address: Select the User IP address mode: 

•  Static: The IP address is manually configured by the User 
•  Dynamic: An assignment request of the IP address is sent by the User. Only 

for IP over PPP 

Local IP: Enter the local IP address. Only in Static mode. 

PPP type: Allows to select the PPP protocol simulation type performed by the 
device: 

•  Client: The device simulates a user terminal, with authentication request to a 

remote server.   

•  Client + link verify: The device, in Client simulation, sends an echo request 

every ten seconds in order to verify if the link is still active. 

•  Server: The device simulates a server and allows to verify the authentication 

phase coming from a remote terminal.     

•  Server + link verify: The device, in Server simulation, sends an echo 

request every ten seconds in order to verify if the link is still active. 

DNS server: Enter the DNS address which allows the solution of names from IP to 
URL and vice versa. 

Once defined the setup to perform the IP Ping test, continue as follows: 

Select ‘Use this setup for testing’. 

Connect the instrument as displayed on the screen and 
press the RIGHT CURSOR key.  

Start the IP PING test.  

 The LED RUN goes on and the test results appear on the screen.  

78

 

                           CHAPTER 3 - PERFORMING A MANUAL TEST