Vidikron VP-5000VHD User Guide
50
Vidikron PlasmaView VHD Installation/Operation Manual
PRE
L
IMINAR
Y
5.2
Troubleshooting Tips
Troubleshooting Tips
Table 5-1 provides some general guidelines for troubleshooting problems you may
encounter with the PlasmaView VHD. If the suggested solutions fail to resolve the problem or
if you encounter an issue not described here, please contact your Vidikron dealer or Vidikron
Technical Support.
encounter with the PlasmaView VHD. If the suggested solutions fail to resolve the problem or
if you encounter an issue not described here, please contact your Vidikron dealer or Vidikron
Technical Support.
Table 5-1. Troubleshooting Chart
Symptom
Possible Cause(s)
Solution
The display does not turn on
after initial installation.
after initial installation.
•
The PlasmaView VHD is not
plugged in or the AC outlet
is not active.
plugged in or the AC outlet
is not active.
•
The
VHD Controller
is not
plugged in or the AC outlet
is not active.
is not active.
•
The remote control
batteries have run out.
batteries have run out.
•
The serial connection from
the VHD Controller to the
PlasmaView VHD is
incorrect.
the VHD Controller to the
PlasmaView VHD is
incorrect.
•
Ensure that the PlasmaView
VHD is plugged in and that
the AC outlet is active.
VHD is plugged in and that
the AC outlet is active.
•
Ensure that the VHD
Controller is plugged in and
that the AC outlet is active.
Controller is plugged in and
that the AC outlet is active.
•
Replace the batteries.
•
Ensure that the RS-232
output from the VHD
Controller is properly
connected to the RS-232C
input on the PlasmaView
VHD (see Figure 3-5).
output from the VHD
Controller is properly
connected to the RS-232C
input on the PlasmaView
VHD (see Figure 3-5).
The PlasmaView VHD and VHD
Controller are both on, but
there is no picture and
on-screen menus do not
appear.
Controller are both on, but
there is no picture and
on-screen menus do not
appear.
•
Faulty or incorrect video
connection between the
VHD Controller and the
PlasmaView VHD.
connection between the
VHD Controller and the
PlasmaView VHD.
•
Ensure that the HDMI
output from the VHD
Controller is properly
connected to the SLOT 2
input on the PlasmaView
VHD (see Figure 3-3 or
Figure 3-4).
output from the VHD
Controller is properly
connected to the SLOT 2
input on the PlasmaView
VHD (see Figure 3-3 or
Figure 3-4).
The display is on and menus
appear, but there is no picture.
appear, but there is no picture.
•
Incorrect source selection.
•
Source component is not
turned on.
turned on.
•
Source component is
connected incorrectly or
not at all.
connected incorrectly or
not at all.
•
Select the correct source.
•
Turn on the source
component.
component.
•
Check connections from
source component to VHD
Controller.
source component to VHD
Controller.
Image is too bright and/or
lacks definition in the bright
areas of the image.
lacks definition in the bright
areas of the image.
•
Contrast is set too high.
•
Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright.
and/or dark areas appear too
bright.
•
Brightness is set too high.
•
Lower the brightness
setting.
setting.