Vornado DVTH User Guide

English 7

If unit has been unplugged, start the unit following the start-up 
instruction (see How To Use). If unit has not been unplugged, just press 
the POWER button and the unit will continue from the last used setting 
before it was turned off.

To use your DVTH as a fan set the MODE to FA (fan only).

Your Vornado DVTH, like other 1,500-Watt electric heaters, draws up to 
12.5 Amps of electric current.  If using your DVTH on HI (high heat) 
mode causes your home circuit breaker to fuse or trip, we offer the 
following suggestions:

Try turning off other electrical appliances that run on the same circuit 
as your heater.

Run your heater on the LO (low heat) mode.

Have your electrician add some additional circuits to your home  
electrical system.

When the room temperature is higher than the set temperature it is 
normal and correct to have little to no heat coming out of the DVTH. 
When the unit is first turned on there is a slight delay before heat will 
start to be produced.

ALWAYS USE COMMON SENSE WHEN USING THIS AND/OR 
ANY ELECTRICAL APPLIANCE

TIGHT GRILL SPIRALS

Resists curious fingers.

COOL TOUCH CASE

Safe to touch, even on high heat setting.

AUTOMATIC SAFETY SHUT OFF SYSTEM

If airflow becomes blocked, power to the heating
element is shut off to prevent overheating.

TIP-OVER PROTECTION

If tipped over, power to the heating element and fan
motor is reduced to prevent overheating.

IDEAL 120°F EXIT AIR TEMPERATURE

Warm enough to heat an entire room.