Canon MF4270 Reference Guide

Page of 272
1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
10-31
Before Using the 
Machine
Document and Paper
Copying
Sending and 
Receiving
Printing and 
Scanning
Network
Remote UI
System Manager 
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
 Entering the fax number is required again after pressing [Start]. 
 Is <CONFIRM FAX NO.> set to <ON>? 
 When <CONFIRM FAX NO.> is set to <ON>, you need 
to enter the fax number again after pressing [Start]. 
(See “Confirming Entered Fax Numbers,” on p. 8-3.) 
 Receiving  Problems 
 Cannot receive a fax automatically. 
 Is the machine set to receive automatically? 
  For the machine to receive faxes automatically, the 
receive mode must be set to <FaxOnly>, <FAX/TEL>, 
<AnsMode>, or <DRPD>. If you have set <AnsMode>, 
confirm that an external telephone with built in 
answering machine is connected to the machine 
and that it is turned on with an outgoing message 
properly recorded. (See “Basic Receiving Method,” on 
p. 4-23.)  
Q
A
Q
A
 Are documents stored in memory, leaving little or 
no memory available? 
 Print, send, or delete any documents stored in 
memory. 
 Has an error occurred during reception? 
 Check the LCD for an error message. (See “LCD 
Messages
,” on p. 10-14.) 
 Print an Activity Report and check for an error. (See 
“ACTIVITY REPORT,” on p. 11-28.) 
 Is paper loaded in the machine? 
 Make sure paper is loaded in the machine. (See “Set 
Up the Machine,” in the Starter Guide.) 
 Is the telephone cable connected properly? 
 Make sure the cable is connected properly. (See 
“Before FAX Setting,” in the Starter Guide.) 
Q
A
Q
A
A
Q
A
Q
A