Canon lbp-3300 Network Guide

Setting Up the Netw

or

k En

vironment f

or Pr

inting

Installing the CAPT Software

Install the printer driver on the computer you are using. The printer driver is 
software required for printing from an application you use. There are the following 
two ways to install the printer driver. The procedures for setting the IP address or 
creating a port (Canon CAPT Port) required to print in a network environment vary 
depending on the installation method.

■ Installing the CAPT Software from CD-ROM Setup (See p. 2-2)

If you install the printer driver from the supplied CD-ROM (CD-ROM Setup), you can 
configure the printer to print in a network environment by setting the IP address and 
creating a port at once.

■ Installing the Printer Driver Manually Using Various Utility Software (See p. 

Specify the IP address or create a port using the software in the supplied CD-ROM 
("NetSpot Device Installer" or "Print Monitor Installer"), the ARP/PING command or 
others, and then install the printer driver from [Add Printer Wizard].

IMPORTANT

The printer driver is required for printing with this printer. Be sure to install the printer 
driver.

NOTE

For procedures for installing the CAPT software by connecting the printer and computer 
with a USB cable or by sharing the printer on a network, see "User's Guide".

This section describes the procedure for installing the printer driver from the 
supplied CD-ROM (CD-ROM Setup). If you install the printer driver from the 
supplied CD-ROM, you can configure the printer to print in a network environment 
by setting the IP address and creating a port at once.

IMPORTANT

When there is not enough free hard disk space, a message will appear during the 
installation. Stop the installation and increase the free space, and then install the CAPT 
software again.

NOTE

The screen shots used in this section are from Windows XP Professional.