Ricoh 3224C User Guide

Page of 192
109
6. Troubleshooting
If Your Machine Does Not Operate As You 
Want
The following chart contains explanations of common problems and messages.
If other messages appear, follow the instructions displayed.
Note
❒ If you cannot make copies as you want because of the paper type, paper size
or paper capacity problems, use recommended paper. See p.167 “Copy Pa-
per”.
General
Problem
Causes
Solutions
Please wait.
” ap-
pears
This message appears 
when you turn on the oper-
ation switch or change the 
toner cartridge.
If the power does not come on even 
after 2 minutes have elapsed, con-
tact your service representative.
The display is off.
The screen contrast knob is 
turned to the dark position.
Set the screen contrast knob to the 
light position to see the display pan-
el properly.
The machine is in Energy 
Saver mode.
Press the 
{{{{Energy Saver}}}} key to can-
cel Energy Saver mode.
The operation switch is 
turned off.
Turn on the operation switch.
Nothing happens when the 
operation switch is turned 
on.
The main power switch is 
turned off.
Turn on the main power switch.
The Earth Leakage Breaker 
is set to Off.
Contact your service representative.
Memory is full.
There are too many 
scanned pages or stored 
files: hard disk capacity is 
exceeded.
Press [Delete File] to delete unneces-
sary documents.
The function status indica-
tor is red.
The function associated 
with the red indicator was 
interrupted.
Press the function key correspond-
ing to the indicator. Follow the in-
structions that appear on the control 
panel.
ThemisC1_EN_zentai_pre_FM.book  Page 109  Thursday, June 30, 2005  8:21 PM