Ricoh 3224C Reference Guide

Administrator Setting

174

C Specify an End Receiver using

❒ One forward destination can

be registered for a destina-
tion. To register two or more
forward destinations, use
Group Destinations. Howev-
er a maximum of 500 parties
can be specified in a group.

❒ Press the button on the right

of the display to switch the
des t in ation  be twe e n  fa x
number, e-mail address, IP-
Fax destination, and folder.

❒ Set a folder destination in

System Initial Setting/Ad-
ministrator Setting/Regis-
ter/Change/Delete Address
Book. “Registering a Folder”,
General Settings Guide.

❒ When a folder is specified as

the forward destination, you
can set a file format for for-
warding. See p.164 “User Pa-
rameters” (switch 21, bit 3).

❒ Deleting a destination speci-

fied as a forward destination
from the destination table
causes the settings of the for-
ward destination to be delet-
ed, so they must be registered
again. When a destination is
changed, a message is trans-
mitted to the new destination.
If there is no destination of the
specified type, you can set a
certain destination to be pri-
ority quoted. See p.164 “User
Parameters” (switch 32, bit 3).

D Press [OK].

❒ After you perform step 

K

, set

“Forwarding” of “Reception
Settings” to “On”. See p.145
“Reception Settings”.

Reception File Print Qty

A Select [Reception File Print Qty].
B Press [Number of Sets].

❒ Selecting  [Same as Basic Set-

 will result in the same

setting made for “RX File
Print Qty” of “Reception Set-
tings”. See p.145 “Reception
Settings”.

ThemisC1_Fax_EN-F_FM.book  Page 174  Tuesday, January 11, 2005  4:59 PM