Frigidaire ffgc2605l User Manual

10

The cooktop is hinged and can be raised to clean the 

area underneath. Be sure all cooktop controls are turned 

to OFF and burner grates are cool.

1.  Remove controls knobs, burner grates and spillover 

bowls. Set aside.

2.  Grasp the front of the cooktop and lift. Some models 

have a swing-up rod to support the cooktop in its 

raised position.

3.  Clean under the cooktop.

4.  Lower the top gently after lowering the support rod 

(some models).

5.  Replace bowls, grates and control knobs.

When lowering the top, grasp the sides with fingertips 

only. Be careful not to pinch fingers. Also, DO NOT drop 

or bend the cooktop when raising or lowering. This 

could damage the surface.

DO NOT turn on the burners when the cooktop is 

raised for cleaning. Be sure that the top is completely 

lowered and securely in place before turning on the 

burners.

The burners on your cooktop maybe removed for cleaning. 

Be sure all controls are turned to OFF and burner grates 

are cool before removing cooktop burner units.

1.  Remove the shipping screws from the support 

bracket. See illustrations for location of screws. 

2.  Grasp the burner head and tilt it to the right to release 

the tab from the burner support (A in Figure 1).

3.  Lift the end of the burner assembly. Then pull away 

from the front of the cooktop to free the air shutter 

from the gas valve orifice (B in Figure 1).

If your cooktop is equipped with a standing gas pilot, use 

caution when removing burner. The flash tube may be 

hot because it is located near the pilot.

Check the lighter and burner ports (Figure 2). If they are 

clogged, use a wire or needle to clear them.

To remove burned-on food, soak the burners in a vinegar 

and water solution for 20-30 minutes. For stubborn 

stains, scrub with soap and water or a mild abrasive 

cleanser and a damp cloth. Do not wash burners in a 

dishwasher.

1.  Slide the air shutter over the gas valve orifice (Figure 

1). 

2.  Lower the burner assembly and hook the tab in the 

slots in the burner support. Make sure it is properly 

seated and level.

3.  Be sure both tabs are in the correct slots, the burner 

sits level and straight, and the flash tube forms a 

straight line from the igniter to the burner (Figure 2).

4.  Replace shipping screws if desired. These screws are 

not necessary for the operation of the burner. They 

stabilize the burner during shipping of the appliance. 

Retain the screws for later use in the event the range 

is moved.