Nortel 1200 Supplementary Manual
10
1
Make certain you are properly grounded electrically.
See
See
.
2
Your OPTera Metro 1200 Ethernet Service Module will
have a blank plate covering the converter module slot on the
back of the module.
have a blank plate covering the converter module slot on the
back of the module.
a
Use a Phillips screwdriver to remove the screws. Insert
a slotted screwdriver gently in the top of the plate, and
press gently away from you to pry the plate loose.
a slotted screwdriver gently in the top of the plate, and
press gently away from you to pry the plate loose.
Note:
Prior to installing the converter module, make sure
you are completely familiar with the requirements of the
BayStack 10 PSU. Review Installation and Reference for
the BayStack 10 Power Supply Unit thoroughly before
beginning to install the converter module.
BayStack 10 PSU. Review Installation and Reference for
the BayStack 10 Power Supply Unit thoroughly before
beginning to install the converter module.
Caution:
When you are using the screwdriver, the
power is ON to the system. Ensure that you insert just the
tip of the screwdriver into the lip of the blank plate; do
not insert the screwdriver into the device.
tip of the screwdriver into the lip of the blank plate; do
not insert the screwdriver into the device.