Extreme x250e-24t Installation Instruction
Summit Family Switches Hardware Installation Guide
131
Figure 99: EPS-LD Connector with Key
To connect the EPS-LD to the switch:
1
Connect the keyed end of the cord to the power supply unit (see
2
Align and tighten the captive retaining screws on the connector.
3
Connect the other end of the EPS-LD cord to the Extreme switch.
The connector fits in only one direction.
NOTE
If your switch was shipped with a metal cover plate over the redundant power input connector, remove the cover.
WARNING!
The redundant power input connector on the rear of the switch contains high energy and is a burn hazard. Use
care when connecting the redundant power supply cord to the rear of the switch.
care when connecting the redundant power supply cord to the rear of the switch.
Figure 100: Connecting an EPS-LD Unit to a Switch
Connecting the EPS-LD to Power
An AC input power cord is not provided with the EPS-LD. For information about power cord
requirements, see
requirements, see
.
Make sure the EPS-LD is connected to the switch before you connect the AC power.
Collin's
ES4K027
XM_055
Collin's
ES4K021A
XM_053
Slot for key
Keyed end of
redundant power cable
To AC
To AC
Extreme switch
EPS-LD
Redundant
power cable