Extreme x250e-24t Installation Instruction
Summit Family Switches Hardware Installation Guide
141
NOTE
An AC power cord is not provided with the EPS-600LS power module. See
for information about selecting a power cord.
Each EPS-C chassis is shipped with a special redundant power supply cord for connection to the Summit switch.
Make sure that the EPS-C chassis is installed in the rack system before installing an EPS-600LS unit.
Make sure that the EPS-C chassis is installed in the rack system before installing an EPS-600LS unit.
Installing an EPS-C Chassis
CAUTION
Do not use the rack mount brackets to suspend the EPS-C from under a table top or desk, or to attach the EPS-C
unit to a wall.
unit to a wall.
The EPS-C is intended for use only with a Summit X450e-48p or X250e-48p switch. You can install the
EPS-C above or below the Summit switch (see
EPS-C above or below the Summit switch (see
).
Figure 109: EPS-C and Summit Switch
To rack-mount the EPS-C:
1
Place the EPS-C upright on a secure work surface.
2
Remove the mounting bracket kit from the packaging.
3
Attach the mounting brackets as follows:
a
Place a rack mount bracket over the mounting holes on one side of the unit.
b
Insert the provided screws and fully tighten them using a screwdriver (see
ESP-C_02
EPS-C
PSU1
DC good
AC good
PSU2 PSU3
STACK NO.
Stack 10G
MGMT
FAN
PSU-1
PSU-E
Solid ON = Link
Blinking = Activity
Blinking = Activity
2
1
1
2
2
1
2
2
4
3
6
5
8
7
10
9
12
11
14
13
16
15
18
17
20
19
22
21
24
23
26
25
28
27
30
29
32
31
34
33
36
35
38
37
40
39
42
41
44
43
46
45
48
47
46X
45X
48X
47X
Shared Ports
Summit X450e-48p Switch
ESP-C