Extreme x250e-24t Installation Instruction
Summit Family Switches Hardware Installation Guide
145
Figure 114: Installing the Redundant Power Cord
6
Connect the other end of the AC power cord to the electrical outlet (see
).
Be sure that the electrical outlet is properly grounded.
7
Repeat steps 1 through 6 for each EPS-600LS unit.
Removing an EPS-600LS Power Module
To manually disconnect an EPS-C or to remove the EPS-600LS modules, the recommended practice is to
disconnect the EPS-600LS modules one at a time, pausing two seconds after each EPS-600LS disconnect.
This enables a graceful power transition from the external PSUs to the internal PSU.
disconnect the EPS-600LS modules one at a time, pausing two seconds after each EPS-600LS disconnect.
This enables a graceful power transition from the external PSUs to the internal PSU.
To remove an EPS-600LS unit:
1
Disconnect the AC power by removing the plug from the wall.
2
Release the cable clip securing the AC power cord to the EPS-600LS unit.
3
Disconnect the AC power cord from the EPS-600LS unit.
4
Loosen the captive screws on the EPS-600LS unit securing it to the EPS-C.
5
Slide the EPS-600LS unit out of the EPS-C.
! See Manual
O.T.P
DC OK
AC OK
EPS-C_06A
To AC
Power Cord
Cable Clip