Extreme 3802 Installation Guide
Installing a BlackDiamond 6800 Series Fan Tray
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
301
Figure 172: Removing the BlackDiamond 6808 fan tray
4
Allow the fan blades to stop spinning; then pull the fan tray the rest of the way out of the chassis.
WARNING!
Keep your hands your away from rotating fan blades.
5
Repeat this procedure for additional fan trays, if applicable.
Leave the ESD strap permanently connected to the chassis so that it is always available when you need
to handle ESD-sensitive components.
to handle ESD-sensitive components.
Installing a BlackDiamond 6800 Series Fan Tray
BlackDiamond 6800 series fan trays are hot-swappable. You do not need to turn off power to a
BlackDiamond 6800 series switch to install a fan tray.
BlackDiamond 6800 series switch to install a fan tray.
You need the following tools and equipment to install a fan tray:
•
ESD-preventive wrist strap
•
# 1 Phillips screwdriver
CAUTION
Only trained service personnel should perform service to BlackDiamond equipment. Before installing or
removing any components, or carrying out any maintenance procedures, see Appendix A.
removing any components, or carrying out any maintenance procedures, see Appendix A.
To install a fan tray in the BlackDiamond 6800 series switch:
1
Attach the ESD strap to your wrist and connect the metal end to the ground receptacle on the top
left corner of the switch front panel.
left corner of the switch front panel.
2
Check the connectors for dust and packing materials.
BD_fanx