Intermec 5020 User Guide
Chapter 5 — 700 Series Mobile Computers (Pocket PC 2003 and Pocket PC 2002)
Data Collection Browser User’s Guide
61
Configuring TCP/IP or UDP Plus on the 700 Series
Before you can run the dcBrowser client, you need to configure your 700
Series for networking and then configure dcBrowser to use either TCP/IP
or UDP Plus.
Series for networking and then configure dcBrowser to use either TCP/IP
or UDP Plus.
The instructions you follow depend on the software your 700 Series is
running:
running:
• If your 700 Series is running Windows Mobile 2003 or Pocket PC
2003, see the instructions in the next section.
• If your 700 Series is running Pocket PC 2002, see
For a 700 Series Running Windows Mobile 2003 or Pocket PC 2003
Follow these steps to configure a 700 Series running Windows Mobile 2003
or Pocket PC 2003.
or Pocket PC 2003.
To configure your 700 Series for networking
1
Select Start > Settings. The Control Panel appears.
2
Tap the Connections tab.
3
Tap Connections.
4
Tap the Advanced tab.
5
Tap Network Card.
6
Select the network adapter you are using for your network
configuration. For example, use the 802.11b PRISM Wireless LAN
adapter if your network is configured with an 802.11b wireless access
point.
configuration. For example, use the 802.11b PRISM Wireless LAN
adapter if your network is configured with an 802.11b wireless access
point.
7
If you are using a dynamic host configuration protocol (DHCP) server,
select Use server-assigned IP address.
select Use server-assigned IP address.
If you are not using a DHCP server, select Use specific IP address and
enter the IP address, subnet mask, and default gateway for your 700
Series. Your network administrator should provide you with this
information.
enter the IP address, subnet mask, and default gateway for your 700
Series. Your network administrator should provide you with this
information.
8
Tap OK. A message appears; tap OK.
What You Need to Configure
Protocol
Additional Items to Configure
TCP/IP
You need to determine the dcBrowser gateway port number (which
defaults to 4055) and the IP address of the computer where the dcBrowser
gateway is hosted.
defaults to 4055) and the IP address of the computer where the dcBrowser
gateway is hosted.
UDP Plus
You need to determine the UDP Plus port number (which defaults to
5555) and the IP address of the controller, which is the Intermec
Application Server or PC that the dcBrowser gateway is running on.
5555) and the IP address of the controller, which is the Intermec
Application Server or PC that the dcBrowser gateway is running on.