Intermec 5020 User Guide

Tap Controller IP. An edit box appears. Tap inside the edit box and 
type the IP address for the controller. Tap outside the edit box to close 
it.

Tap Controller Port if you need to change the port number (which 
defaults to 5555) to match the port configured for UDP Plus on the 
controller. An edit box appears. Tap inside the edit box and type the 
port number. Tap outside the edit box to close it.

Tap the round X button in the upper right corner of the screen. The 
“Save configuration changes?” prompt appears.

Tap Yes to save the changes.

To close Intermec Settings, tap the round X button in the upper right 
corner of the screen.

Perform the steps in 

Follow these steps to configure a 700 Series running Pocket PC 2002.

Select Start > Settings. The Control Panel appears.

Tap the Connections tab.

Tap Network.

Under Adapters installed, tap the Ethernet card driver you are using for 
your network. 

If you are using a dynamic host configuration protocol (DHCP) server, 
select Use server-assigned IP address.

If you are not using a DHCP server, select Use specific IP address and 
enter the IP address, subnet mask, and default gateway for your 700 
Series. Your network administrator should provide you with this 
information.

Tap OK. A message appears; tap OK.

Tap the System tab and tap Wireless Network.

Choose Access Point and tap Edit Profile.

In the Network Name field, enter the network name.

Tap the OK button near the bottom of the screen. Tap it again when the 
next screen appears.

To exit the Control Panel, tap the round X button in the upper right 
corner of the screen.

Perform the steps in one of the next two procedures to configure 
dcBrowser for either TCP/IP or UDP Plus.