Intermec cn2a User Guide
Chapter 1 — Using the CN2A Mobile Computer
18
CN2A Mobile Computer User’s Manual
Understanding the Beeps
The CN2A uses beeps to provide you with audio feedback when
it performs some functions. For example, you hear a beep each
time you scan a valid bar code.
it performs some functions. For example, you hear a beep each
time you scan a valid bar code.
You can change the beeper volume for your needs and
environment. You can set the beeper volume to Off, Low (quiet),
Medium (medium), High (loud), and Very high (very loud).
The default setting is Very high.
environment. You can set the beeper volume to Off, Low (quiet),
Medium (medium), High (loud), and Very high (very loud).
The default setting is Very high.
Understanding the CN2A Status Lights
Light
Color
Description
Good Read
Green
This light turns on when the CN2A
successfully decodes a bar code.
successfully decodes a bar code.
Red
This light turns on when you press one of
the Side Scan buttons or the Scan button
on the scroll keypad.
the Side Scan buttons or the Scan button
on the scroll keypad.
Battery
Green
When the CN2A is connected to a power
source, this light turns on to indicate that
the battery is fully charged.
source, this light turns on to indicate that
the battery is fully charged.
Orange
When the CN2A is connected to a power
source, this light turns on if you cannot
charge the battery. The temperature may
not be within the charging range, or the
battery may be damaged.
source, this light turns on if you cannot
charge the battery. The temperature may
not be within the charging range, or the
battery may be damaged.
Red
When the CN2A is connected to a power
source, this light turns on to indicate that
the battery is charging.
source, this light turns on to indicate that
the battery is charging.
Understanding the CN2A Beeps
Beep Sequence
What It Means
High beep, low beep
You entered valid data or a valid command, or
the CN2A decoded a bar code label.
the CN2A decoded a bar code label.
Error beep (3 rapid
beeps)
beeps)
You entered or scanned an invalid command.
Try entering or scanning the command again.
Try entering or scanning the command again.
Click
You pressed a key.