Intermec cn2a User Guide
Chapter 3 — Adding the CN2A to the Network
CN2A Mobile Computer User’s Manual
45
To use USB communications with your CN2A
1
Connect the USB client dock to the USB port of the other
device using an appropriate USB cable.
device using an appropriate USB cable.
2
Make sure that your USB device is configured for USB
communications.
communications.
3
Insert the CN2A into the USB client dock.
4
Turn on the CN2A.
For more information about the USB client dock, see the
instructions that shipped with the dock.
instructions that shipped with the dock.
Configuring 802.11b/g Radio Communications
The wireless CN2A has an internal 802.11b/g radio to transfer
data using wireless communications. This section of the manual
assumes that you have already set up your wireless
communications network including your access points. If you are
using a UDP Plus network, you also need to have your Intermec
Application Server communicating with a host computer.
data using wireless communications. This section of the manual
assumes that you have already set up your wireless
communications network including your access points. If you are
using a UDP Plus network, you also need to have your Intermec
Application Server communicating with a host computer.
Your CN2A supports these network protocols:
• TCP/IP
• UDP Plus
The next sections explain the parameters you need to configure
for the CN2A to work in your wireless network.
for the CN2A to work in your wireless network.
Make sure all components with antennas are at least 30 cm
(1 ft) apart when power is applied. Failure to comply could
result in equipment damage.
result in equipment damage.