Intermec 6622 User Guide
SECTION 6
"
Troubleshooting
6-4
PEN*KEY
R
6622 Pen Computer User’s Guide
Data cannot be written to or read from
the hard disk.
"
Confirm that the hard disk has been formatted properly and that
the areas have been setup properly with the FDISK command.
the areas have been setup properly with the FDISK command.
If these cannot be performed properly, make sure that, under
the Security menu of the Setup utility, “Fixed disk boot sector” is
not set to “Write Protect.”
the Security menu of the Setup utility, “Fixed disk boot sector” is
not set to “Write Protect.”
"
Confirm that the drive specification is correct.
"
Confirm that the file name specification is correct.
"
Confirm that the hard disk has enough free space.
"
The message “Not a system disk” or a disk error message ap-
pears.
pears.
"
Check whether the drive type is correct or not in the Setup util-
ity.
ity.
"
If the message is displayed when starting up from a hard disk
drive, insert a boot floppy disk, start up the system, and then
check the status of the hard disk drive.
drive, insert a boot floppy disk, start up the system, and then
check the status of the hard disk drive.
An expansion device or peripheral de-
vice does not function.
"
Confirm that the device is installed properly. Refer to Section 5,
“Connecting Peripheral Equipment.”
“Connecting Peripheral Equipment.”
"
Confirm that the device driver required by the expansion device
has been installed in the system.
has been installed in the system.
Output cannot be directed to the print-
er.
"
Confirm that the printer power is on.
"
Confirm that the printer is connected properly to the pen termi-
nal.
nal.
"
Confirm that the printer is in the on line state.
"
Confirm that paper has been loaded in the printer properly.
"
Confirm that under Integrated Peripherals in the Advanced
menu of the Setup utility, “Parallel Port” is set to “Bi direction-
al.”
menu of the Setup utility, “Parallel Port” is set to “Bi direction-
al.”