Intermec jg2050 Reference Guide
JANUS 2.4 GHz Radio Frequency Quick Reference Guide
6
• Use the JANUS 2.4 GHz Installation Utility to install the network software
and set the network and radio parameters on your JANUS device.
Attaching the Antenna
Caution
The antenna must be attached before turning on the JANUS RF
device. The internal radio could be damaged if the antenna is not
attached.
The antenna must be attached before turning on the JANUS RF
device. The internal radio could be damaged if the antenna is not
attached.
Conseil
Si l’antenna n’est pas attachée avant que l’appareil RF de JANUS
soit mise sous tension, la radio interne peut être endommagée.
Si l’antenna n’est pas attachée avant que l’appareil RF de JANUS
soit mise sous tension, la radio interne peut être endommagée.
Note:
Do not interchange antennas between any of the JANUS RF devices. Each
antenna is built specifically for the radio that is installed in the device.
1. Make sure the JANUS RF device is switched off. If the device is on, switch
it off by pressing
q
.
2. Screw the antenna into the connector of the device. Refer to the following
illustrations.
3. Switch on the device by pressing
q
.
Attaching the J2050A or JG2050 Antenna
2050U.009