Intermec 2400 User Guide

1

2

1

2

When a battery pack is loaded
on the  2  side of the charger,
status light 2 is on.

Adjacent
charging 
slots

Note:
A battery pack usually
takes two hours to charge.
If you load two battery packs 
in adjacent slots, then each
battery pack takes four
hours to charge.

When a battery pack is loaded
on the  1  side of the charger,
status light 1 is on.

Attach the 
Intermec power
cord here.

Adjacent
charging
slots

Battery
pack

4PACK.001

2

1

For security purposes, you may want to install the battery charger as
described below. Steps 1 and 2 are optional.

1.

Attach the two sheet metal mounting straps to the bottom of the
battery charger with the two flathead screws provided.

2.

Attach the battery charger to a clean, stable, flat work surface using
your own screws or bolts (up to 1/2 inch diameter).

3.

Plug the power cord into the charger and a wall outlet. If you do not
have a power cord, see “Ordering Power Cords for the Battery
Charger.”

You can charge up to four battery packs simultaneously, and you can
load the battery packs into any slot. The charging time depends on the
condition of the battery pack. Usually a battery pack is fully charged in
two hours. If two battery packs are in adjacent slots, each may take four
hours to charge.

Press the battery pack against the battery charger and slide the battery
pack down until it is seated firmly in the charger.

Each charger slot has an orange status light which indicates the status of
the battery pack in the slot. Next to each light is a line which points to the
slot the light is for. Use this table to interpret the status lights:

On

The battery pack is charging.

Blinking

The battery pack is charging, but has not been charged for awhile.

One Blink

You loaded a fully charged battery pack.

Off

Charging is complete.

To unload a battery pack from the charger, slide it up in the opposite
direction from when you loaded it. You can unload and use a battery
pack before it has been fully charged.