Intermec 2430 User Guide

 

Or:  To disable the configuration commands via serial port for each serial port, 

scan these bar codes: 

COM1 Commands Via 

COM2 Commands Via  

Serial Port Disabled  

Serial Port Disabled 

*$+YT1.0* 

*$+YT2.0* 

*$+YT1.0* $+YT2.0* 
COM3 Commands Via 

COM4 Commands  

Serial Port Disabled 

Via Serial Port Disabled 

*$+YT3.0* 

*$+YT4.0* 

*$+YT3.0* *$+YT4.0* 

 

Or:  To set the configuration commands via serial port to enabled with TMF 

for each serial port, scan these bar codes: 

COM1 Commands Via 

COM2 Commands Via 

Serial Port Enabled With TMF 

Serial Port Enabled With TMF 

*$+YT1.1* 

*$+YT2.1* 

*$+YT1.1* $+YT2.1* 
COM3 Commands Via 

COM4 Commands Via 

Serial Port Enabled With TMF 

Serial Port Enabled With TMF 

*$+YT3.1* 

*$+YT4.1* 

*$+YT3.1* *$+YT4.1* 

 

Terminals:  2415, 2425, 2435, 2455, 2475, and 2485/6. 

 

Description:  During periods of inactivity on the terminal, the terminal still sends 

messages to the Intermec Gateway or DCS 30X to check the RF or 
Ethernet connection. If no message is received within the time set for the 
Controller Connect Check Receive Timer, the terminal is no longer 
connected to the Intermec Gateway or DCS 30X and the Network 
Connect status light (or the Connect LED or the Connect icon) blinks. 
The timer countdown resets each time a valid message is received. 

Power Management Tip: Intermec strongly recommends that you use the 
optimum setting of 60 seconds. 

 

Syntax: NPdata 

Acceptable values for data are any number from 1 to 3600 seconds (60 
minutes). 

 

Default: 60 

seconds 

 

Menu System:  Main Menu > Configuration Menu > Communications Menu > Advanced 

Network