Intermec 2430 User Guide

Scan the serial port from these bar codes: 

 COM1 

COM2 

 

*1/N* 

*2/N* 

 *1.* 

*2.* 

 COM3 

COM4 

 

*3/N* 

*4/N* 

 *3

.

* *4

.

* 

Scan one or two bar codes for data from the “Full ASCII Bar Code 
Chart” on page 284. 

Scan this bar code: 

  Exit Accumulate Mode 

 

*/M/O* 

 *-/* 

Repeat Steps 2 through 4 to set EOM for another serial port. 

 

Terminals:  All Trakker Antares terminals. 

 

Description:  Configures the use of the optional 2MB extended flash memory. If you 

have a terminal with the 4MB flash memory option, you can either 
configure the extra 2MB of flash memory as a drive D, or you can use it to 
store double-byte fonts. You cannot use the space for both. If you 
configure the flash memory as drive D, use this drive to store large lookup 
tables and data files. You can store up to 128 files on drive D or store up 
to 2MB of double-byte fonts.  

After you configure the flash memory, you must save the configuration in 
flash memory and boot the terminal for the change to take effect. 

 

Note: The 4MB flash memory is required for 802.1x TTLS security. If 
you have the 802.1x TTLS security option, you cannot configure Flash 
Memory Configuration. For more information about configuring 802.1x 
TTLS security, see “Configuring 802.1x TTLS Security” in the 
networking chapter of your user’s manual. 

 

Syntax: FFdata 

Acceptable values for data are: 

0 

Configure flash memory for double-byte fonts 

32  Configure flash memory as the 2MB drive D 

 

Default:  0 (Configure flash memory for double-byte fonts) 

 

Menu System: Not 

supported