Intermec 2430 User Guide

 

Bar Codes:  To set Flash Memory Configuration: 

Scan one of these bar codes to configure flash memory: 

  Configure Flash Memory 

  For Double-Byte Fonts  

Configure Flash Memory as Drive D 

 

*$+FF0* 

*$+FF32* 

 *$+FF0* 

*$+FF32* 

To save the changes in flash memory, scan this bar code: 

  Save Configuration in Flash Memory 

 

*.+1* 

 *.+1* 

Scan this bar code to boot the terminal and use the 2MB flash memory 
to store double-byte fonts or as drive D: 

 Reset 

Firmware 

 

*-.* 

 *-.* 

 

Note: When you boot or reset the terminal, any fonts or files in flash 
memory on drive D are erased. 

If you configured flash memory to store double-byte fonts, use the 
Trakker Antares Font Editor to download the double-byte font set to 
the terminal. See your local Intermec sales representative for 
information about the Trakker Antares Font Editor. 

 

Terminals:  All Trakker Antares terminals. 

 

Description:  Regulates the data transmission through the serial port. The terminal is a 

DTE (Data Terminal Equipment) device. There are several flow control 
options: 

•  CTS checking where Clear To Send (CTS) is a hardware signal flow 

control. The terminal sets and clears Request To Send (RTS) when it is 
ready to receive. The terminal checks CTS when it tries to transmit 
data. 

•  XON/XOFF response causes the terminal to respond to XON/XOFF 

characters received while transmitting. 

•  XON/XOFF control specifies that the terminal transmits XON/XOFF 

characters to control the incoming data flow. 

•  XON/XOFF response and control specify that the terminal responds to 

and transmits XON/XOFF characters.